Faux wood garage doors

     There's nothing like the look and feel of real wood with a deep warm stain, it's so elegant. The homeowner decided that the original off white  painted  doors needed to be changed.

     Do we change the doors to real wood which would cost a small fortune or faux them to match our front entry door. Well as you can see they went for the faux wood, great choice!

     Faux wood applied correctly can give the illusion of real wood and feel real to the touch, that's what faux is all about, fool the eye and everything follows. In the picture above I have the sequence of steps which I needed to take to build up the faux wood.

     The first door on the right I used base paint from Benjimen Moore Moreguard exterior latex # 1110. I applied only one coat and painted with a three inch brush going in the direction of the grain.
The doors were originally off white so I let a little of that come threw to add depth. I like to start the grain pattern right away if I can. Starting with a solid base is satisfactory.

     The middle door - I started to apply the first glaze B.M. Mooreguard Charleston Brown in the panels of the door. At this point my brush strokes were going in a horizontal pattern, side to side leaving some of the base showing threw. Each panel needs to have it's own personality so try not to repeat the same pattern.

     Door on the left shows the grain pattern running left to right. Normally the pattern would be horizontal with this door design and the grain would run up and down on the vertical frame pieces. I felt in this situation I would run the grain horizontally. These doors originally had smooth wood and were spray painted unlike the stamped metal doors that have grain running the same way threw out the entire door. I mentioned this because the grain comes out much better with a smooth base. The faux technique for metal doors is much different.

    Finally, the picture below shows a rich warm color and a nice sheen. I used B.M. Mooreguard #2107-10 in glaze. Take special care to apply the grain to each panel first and then the frames. Don't cover your work completely, let the under glazes show threw. Some areas I added straight paint # 2107-10 to create a more defined grain using an artist brush. Keep your grain random, try not to repeat the same pattern.

Click on to enlarge

    Protective finish - After the paint is fully dried I added a little ultramarine blue oil base artist color out of the tube to Exterior Spar varnish to reduce the orange color. To do this on your first coat mix 50/50 spar varnish and mineral spirits plus a dab of blue. Check on a sample board to see if your satisfied with the results. If your happy move forward apply this coat, let dry and then apply 100% exterior spar varnish.

   Now sit back in your driveway and admire your work!