As you can see there is a very long tear running across the base of the wall. This happens when the base boards are removed without scoring the tops of the base were it meets the wall. You can save yourself a lot of work by running a razor blade along the top of the base lightly cutting into the paint and caulk. When you remove the base you will have minimal damage. Supplies needed for repair: Razor knife, 6" metal compound blade, 150 grit sandpaper or block, drywall compound, oil primer, latex primer, Paint brushes, rags, paint and don't forget patience.
Before you apply the oil base primer cut the loose pieces of drywall with your razor knife.
The brown paper will need to be primed to keep it from bubbling once the compound is applied.
Let the oil base primer dry. Now lightly sand the raised areas using the 150 grit paper or block and cut away any paper which my be sticking out.
Once the second coat is dry its time to sand the
area with 150 grit paper or block. I start at the top or outer section and work my way into the center. Be careful not to sand so deep into your work. The repair is very thin and will not need excessive sanding. Wipe off the dust with your damp rag and take a look to see if you need another coat of compound. You may need just a touch up or two. If you are pleased, apply your water based primer. Once dry apply your finish coats. If you see anything that you don't like after you paint, you can apply compound to the spots and repeat the above. Good luck and have Fun !
NOTE : Please follow label instructions for all products used and how to discard any waste.
No comments:
Post a Comment